Brush clipping (Proper windows and doors)
Posted: November 17th, 2005, 8:45 pm
This tutorial is going to teach how to clip walls basicly. think of it as a pair of scissors
u tell it where it cut though..
1. Highlight a brush you want cut
2. Press "x" or Select > Clipper > Toggle
3. In the right view u want probally front view
4. Click somewhere then click somewhere else to cut
5. Add a actor (Any actor this is just so we can get the size of door)
6. place him by the wall
7. Clip 2 units above it (Grid setting : Grid 8 shortcut : 4)
8. Then clip 2 units wider than your actor
9. Select the remaining brush inside the middle
10. Press backspace
And whowwwlaa
Hopefully you will not use the "CSG Subtract" tool now.. which will cause
compilation errors!
u tell it where it cut though..
1. Highlight a brush you want cut
2. Press "x" or Select > Clipper > Toggle
3. In the right view u want probally front view
4. Click somewhere then click somewhere else to cut
5. Add a actor (Any actor this is just so we can get the size of door)
6. place him by the wall
7. Clip 2 units above it (Grid setting : Grid 8 shortcut : 4)
8. Then clip 2 units wider than your actor
9. Select the remaining brush inside the middle
10. Press backspace
And whowwwlaa
Hopefully you will not use the "CSG Subtract" tool now.. which will cause
compilation errors!
if we get gd tuts on here. we wont need modsonline!