CoDJumper.com

I was working on my map (this was a few compiles ago) a small section of my map appeared to have the red tint effect
here is a picture


As you can see it's just in that one particular area, and no where else. When this first occurred i thought i just needed to compile my reflections ( As i don't every time unless i added light or did some major changes) so i recompiled everything multiple times, i switched my BSP options from Fast to Extra to see if that did anything and it did not. So then i tried moving reflections probes around to see if that was the issue, that had no effect. Any and all help would be appreciated.

-TechPB

Try pressing shift+L to enter lightmap mode, then see if that area is any different than the rest.

I did as you said and did not find anything, i took a screen shot just to make sure.

inside the rectangle is approximately where i am having the issue on the map.

Do you have any red lights next to that area?

No, There aren't any near that area or even in my map.

1. Delete and remake.
2. Make sure all filters are off (so you can see everything).

Copy and paste to a new map before you remake it. That usually fixes stuff.

Ok, Thanks for the help, i going to finish up my work on the map and see if it somehow fixes its self and then, if it doesn't ill put it in a new .map, i have done that 3 times already lol, just wanted to see if you guys knew what it was before i did all that. Thanks for the help guys